.. include:: ../text_colors.rst
.. toctree::

.. |propeller_name| replace:: UPF-23-12
.. |motor_name| replace:: Vertiq 23-06

.. _up12_installation_tutorial:

*********************************************
Installing |propeller_name| on a |motor_name|
*********************************************
.. figure:: ../_static/tutorial_images/up12_installation/annotated_propeller.png
    :align: center
    :scale: 50
    :alt: Annotated |propeller_name|

    Annotated |propeller_name|

To install the |propeller_name| on a |motor_name| module, you must first remove the main shoulder bolt from the adapter. Be sure not to lose the two washers on either side of the propeller hub. 

.. figure:: ../_static/tutorial_images/up12_installation/hub_removed.jpg
    :align: center
    :scale: 15
    :alt: Hub removed from adapter

    Adapter and Hub Separated

Use the supplied M2x6 Screws to mount the adapter to the |motor_name|.

.. figure:: ../_static/tutorial_images/up12_installation/adp_mounted.jpg
    :align: center
    :scale: 15
    :alt: Adapter mounted to module

    Adapter mounted to module

Re-attach the propeller hub to the adapter. When tightening the main shoulder bolt, continue tightening until the hub does not spin freely. Loosen the bolt ¼ turn at a time until it again spins freely. There should be very little axial play of the hub along the main shoulder bolt.

.. figure:: ../_static/tutorial_images/up12_installation/propeller.jpg
    :align: center
    :scale: 15
    :alt: |propeller_name| on |motor_name|

    |propeller_name| on |motor_name|